Power Fist 8661621 Mode D'emploi page 7

V4.0
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
The water pump will require setup and will be ready for use after it has been
properly serviced with the recommended oil and fuel. Please contact Princess
Auto Ltd. if you have any problems with the setup of your water pump. Please
have the model and serial number from the data tag available.
SUCTION & DISCHARGE HOSES
There are multiple ways to connect the suction and discharge hoses to the pump.
1. Hose Coupler – A barbed hose coupler is placed over the inlet or discharge
port (Fig. 2-4) and fixed into place by a hose ring (Fig. 2-3) that screws
into place. A hose end is then fitted over the barbed coupler (Fig. 2-1) and
fixed into place using hose clamps (Fig. 2-2). Tighten the hose clamp
securely using a standard 6 mm screwdriver. Rubber seals are required.
2. Threaded Connection – The intake and discharge ports have male threads.
Commercial hoses will have a compatible female thread. A rubber seal will
be required to prevent leaks.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
3 in. Gas Water Pump 8661621
Fig. 2
7