Uline H-7229 Instructions D'installation page 2

1. Attach end caps to seat planks and foot planks.
Make sure the pre-drilled holes on the end caps
are on the underside of the planks. Use a rubber
mallet to tap into place. Attach with a drill, #2
Phillips bit and #8 x 1/2" self-tapping stainless screws.
(See Figure 1)
#8 x 1/2" Self-Tapping Screws
2 x 10 Plank (upside down)
Figure 1
2. Assemble X-braces. Place the pieces together flat
side to flat side. Attach with a 3/8" bolt and flange
nut through the center hole. Hand tighten.
(See Figures 2 and 3)
Figure 2
3/8" Bolt and Flange Nut
Figure 3
PAGE 2 OF 12
ASSEMBLY
2 x 10 End Cap
3. Position frames in place, standing up, 6 feet apart.
(See Figure 4)
Figure 4
4. Working from the back of the frames, attach the
assembled X-brace. Secure X-braces to third hole
up from bottom and other end to bottom hole on
opposite bleacher frame. Attach with 3/8" bolts and
flange nuts. Hand tighten. (See Figures 5 and 6)
NOTE: Not all holes on the frame will be used.
Figure 5
Figure 6
Flange Nut
6'
Bleacher Frame
Bleacher Frame
X-Brace
3/8" Bolt
0922 IH-7229