Uline H-7229 Instructions D'installation page 4

9. Underneath the foot plank, turn the clips vertical so
the grooves of the clip fit securely under the channel
lips. Tighten the clips with flange nuts.
(See Figures 12-14)
Figure 12
Figure 14
5/16" Carriage Bolt
Flange
Nut
10. Attach the seat planks. Starting from the top row,
place one seat plank on top of the clips, making
sure the clips are resting under the plank in the
outside channels. (See Figure 15)
Figure 15
Seat Plank
Foot Plank
PAGE 4 OF 12
ASSEMBLY CONTINUED
Figure 13
Hold Down Clip
Frame
11. The seat planks should have a 9" overhang on
both ends, measuring from the center of the frame.
Make sure the seat end is square with the foot
planks (should line up corner to side). Repeat for the
remaining seat planks. (See Figure 16)
12. Underneath the foot plank, turn the clips vertical
so the grooves of the clip fit securely under the
channel lips. Tighten the clips with flange nuts.
(See Figures 12-14)
13. Check and tighten all flange nuts with socket
wrench.
1-800-295-5510
uline.com
Figure 16
0922 IH-7229