Uline H-7229 Instructions D'installation page 3

5. At this point frame is able to stand up on its own.
Make sure the frame is straight, square and level.
Tighten all 3/8" bolt connections with socket wrench.
(See Figure 7)
Figure 7
6. On the frame, place a clip on each hole of the
seat and foot braces. On the foot braces, use the
intermediate holes. The clips should have the center
indent facing up and be horizontal. Insert 5/16"
carriage bolt through each clip and frame and
attach nut loosely. (See Figures 8 and 9)
Figure 8
Figure 9
Intermediate
PAGE 3 OF 12
ASSEMBLY CONTINUED
Clip
Holes
7. Attach foot planks. Beginning with the bottom
row, place one foot plank on top of the clips,
making sure the clips rest under the plank in the
outside channels. The foot plank should have a 9"
overhang on both ends, measuring from the center
of the frame. Repeat for second foot plank.
(See Figure 10)
8. Confirm the frame is straight and square. Center of
the left foot plank frame to center of the right foot
plank frame should measure 6' on center.
(See Figure 11)
Figure 10
9"
6'
Figure 11
0922 IH-7229