Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Contents of Carton
1 - Air Compressor
2 - Wheels
2 - Shoulder Bolts, 3/8-16
2 - Hex Nuts, 3/8-16
2 - Molded Foot Bumpers
1 - Handle
1 - Handle Grip
2 - Screws, #10-16 x 1.00
Tools Required for
Assembly
1 - 9/16" socket or open end
wrench
1 - 3/8" socket
Installing Handles,
Wheels, and Molded Foot
Bumpers
The wheels
and handle
do not provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
1.
Submerge handle grip into warm
soapy water to make installation
easier. Remove handle grip from
soapy water and slide onto
handle.
2.
Slide handle through holes in
compressor saddle onto tabs.
Secure with screws, one on each
side.
Compressor Saddle
Handle Screw
A08600
ASSEMBLY
one side of the outfit when
installing the wheels because the
compressor will have a tendency to
tip over.
3.
Install one shoulder bolt and one
nut for each wheel. Tighten
securely. The outfit will sit level
if the wheels are properly
installed.
Nut
4.
Clean and dry underside of air
tank leg opposite wheels.
Remove the protective strip from
the adhesive backed molded foot
bumpers. Attach the foot
bumpers to the bottom of leg on
each end. Press firmly into
place.
Molded Foot Bumpers
Tab
10- ENG
It will be necessary
to brace or support
Wheel
Shoulder Bolt
Publicité
