Publicité
Les langues disponibles
Les langues disponibles
Step 3: Attach and Adjust the Handlebar.
1.
Remove either one of the Wrenches from under the Access Cover and close the Cover (Figure 2 on page 5).
2.
Lay the Handlebar on top of the Mower and align the two (2) holes as shown in Figure 3.
3.
Insert a 8mm x 38mm Shoulder Bolt from the inside through the aligned holes (Figure 4), attach a 8mm Lock Nut and
repeat for other side. Tighten the Lock Nuts using the small Hexagonal end of the Wrench and a Phillips Screwdriver.
Figure 3
4.
Rotate the Handlebar into the upright position. The Handlebar will lock into its highest position producing an audible
click. Note the Silver Pin protruding through the hole in the Steel Plate (Figure 5).
5.
Unsnap the Handlebar Cable (Female End) from the Main Cable Holder (Figure 4).
6.
Locate the Male End of the Main Cable from the Mower (Figure 6a), line up the raised Arrows (Figure 6b) on each
connector, and push the connectors together until fully mated (Figure 6b).
7.
Snap the mated connectors into the Main Cable Holder on the Handlebar (Figure 6c) and then snap the Protective Cover
over the mated connectors.
Silver Pin
Figure 5
8.
To adjust the Handlebar height, pull the right Knob
(Figure 7) all the way out and twist the Knob in either
direction 1/4 turn. This will lock the Knob in the out
position.
9.
While holding the Handlebar, pull the left Knob (Figure 8)
all the way out and rotate the Handlebar to the desired
position. Release the Knob and move the Handlebar until
the Knob clicks back into position with an audible "click".
Make sure the Silver Pin is protruding through one of the
four (4) Height Adjustment holes in the Steel Plate.
10. Slowly twist the right Knob until it locks into position with
an audible "click". Check to make sure both Silver Pins are
protruding though their respective holes in the Steel
Plates.
6
Steel
Plate
Male End
(to Mower)
Figure 6a
Main Cable Holder
Holes
aligned
8mm Lock Nut
Figure 4
Female End
(to Handlebar)
Figure 6b
Steel Plate
Figure 7
8mm x 38mm
Shoulder Bolts
Protective
Cover
Raised
Arrows
Push to
snap in
place.
Figure 6c
Figure 8
www.neutonpower.com
8mm Lock Nut
Handlebar
Cable
(Female End)
Steel Plate
Publicité
