Neuton CE 6.3 Mode D'emploi page 13

Controls and Features
⇒
Status Indicator Light
The green Status Indicator Light (Figure 23) on the Lower
Crossbar lights up when you install a charged Battery, insert the
Safety Key and when you place the Power/Mode Switch in either
the Mow or Auxiliary position.
NOTE: A green Status Indicator Light does not guarantee that the
Battery is fully charged, only that it has some charge, the
Safety Key has been inserted, the electrical system is ready,
and that the Mower can be started.
If the green Status Indicator Light goes out, do not operate the Mower again until the Battery is fully charged. If you do operate
the Mower with the green Status Indicator Light out, this will result in decreased charging capacity.
NOTE: Although you may notice that a short period of rest may restore the Status Indicator Light, you still must fully charge the
Battery before continuing to mow. For best results, be sure to fully charge the Battery for twenty-four (24) to seventy-
two (72) hours after every use.
⇒
Power/Mode Switch
The Power/Mode Switch (Figure 24) controls the Mower, Power,
and optional Trimmer. This Switch has three (3) settings.
•
Mower (rear position), used for normal mowing; and
•
Power OFF (center position), used to conserve Battery power
(green Status Indicator Light goes out); and
•
Auxiliary (forward position), used when operating the Optional
Trimmer.
⇒
Analog Voltage Gauge
The Analog Voltage Gauge (Figure 25) indicates the amount of
Battery life remaining. The yellow area indicates acceptable
voltage whereas the red area indicates low voltage. You should
raise the Cutting Height or mow slower if the gauge momentarily
drops into the red area. Recharge the Battery if the Gauge stays in
the red area.
NEUTON CE 6.3 Battery-Powered Mower - Safety & Operating Instructions
Status Indicator Light
Figure 23
Power/Mode Switch
Figure 24
Analog Voltage Gauge
Figure 25
11