Publicité
Les langues disponibles
Les langues disponibles
Rear Bagger
The NEUTON Rear Bagger lets you cut and catch your grass clippings, eliminating the need to rake. The Rear Bagger
easily attaches to the rear of the Mower (Figure 12). The Bagger shipped unassembled. The following instructions
outline the steps necessary to assemble, install, and remove the Bagger.
Assembling the Bag to the Bag Frame
1.
With the Bottom Stiffener Board facing down, insert the Frame into the Bag (Figure 13).
2.
Snap the Bag Clips around the Frame top, sides and bottom (Figure 14) to secure the Bag to the Frame.
Rear Bagger
Figure 12
Installing the Bagger
1.
Raise the Discharge Guard on your Mower (Figure 15) and note the metal Support Rod at the rear of the Mower.
2.
Grasp the Bagger by the Top Handle (Figure 16) and center it at the back of the Mower.
3.
Align the Metal Latch Hooks (Figure 16) over the Support Rod (Figure 17) and lower the Bagger in place until the Wire
Frame at the bottom of the Bagger rests on the Mower. Lower the Discharge Guard.
Removing and Emptying the Bagger
1.
Raise the Discharge Guard and using the Top Handle of the Bagger, lift the Bagger off the Support Rod and away from the
Mower. Lower the Discharge Guard.
2.
To empty the Bagger, tilt the Top Handle forward. Use the Cloth Handle (Figure 18) at the rear of the Bagger to move the
contents toward the front as you empty the Bagger.
Discharge
Guard
Figure 15
Latch Hook
Figure 17
8
Frame
Figure 13
Support Rod
Support Rod
Stiffener Board
Figure 16
Figure 18
Bag Clips
Figure 14
Latch Hooks
Top Handle
Cloth
Handle
www.neutonpower.com
Publicité
