Peavey Architectural Acoustics MMA81502 Mode D'emploi page 11

MMA81502 (230V)
MMA8752 (120/230V)
All manuals and user guides at all-guides.com
The loudspeaker outputs of the mixer/amplifier are 4 Ohms, 8 Ohms, 70V and 100V. Connect
the loudspeaker system to any ONE of these outputs. Class 2 wiring may be used.
There are two types of output: 4 Ohm Direct Output;
The method of connection differs in each case. Refer to Figure 5. If using the transformer
isolated outputs be sure that the Low Cut switch is ON.
Note: Impedance values shown in Figure 5 indicate total loudspeaker system (load) impedance.
The loudspeaker outputs of the mixer/amplifier are 4 Ohms, 8 Ohms/25V, 70V and 100V.
Connect the loudspeaker system to any ONE of these outputs. Class 2 wiring may be used.
There are two types of output: 4 Ohm Direct Output;
The method of connection differs in each case. Refer to Figure 6. If using the transformer
isolated outputs be sure that the Low Cut switch is ON.
Note: Impedance values shown in Figure 6 indicate total loudspeaker system (load) impedance.
8 Ohm, 70V, and 100V via Output Transformer
Figure 5
8 Ohm/25V, 70V, and 100V via Output Transformer
Figure 6
11