bloom fresco Instructions D'installation page 20

a Base and Seat Assembly
(#01 swivel shaft, #02 base, #14 swivel shaft
housing) Insert the swivel shaft to base by
aligning the 'unlock' icon marking on the swivel
shaft to the indication line marked on the base.
Turn until locked into position. You will hear an
audible click. In locked position the indication
line should point to the 'lock' icon. Check the
swivel shaft is securely locked by lifting upwards.
Press shaft button to raise swivel shaft.
To dissemble, lift the slide button on side of
swivel shaft whilst turning to align the 'unlock'
icon to indication line. Pull to remove.
(#10 seat unit) Insert the seat unit onto swivel
shaft and tighten fastener clockwise. Check seat
unit is secured by pulling seat unit upwards.
a Swivel and Height Adjustment
To rotate the seat unit, disengage the swivel/
height resistor, then turn the seat unit sideways
to desired position.
To adjust seat height, disengage the
swivel/height resistor. Lift both A & B trigger
simultaneously, whilst pushing downwards or
pulling upwards to desired height, then release
the triggers.
IMPORTANT!
Ensure the seat unit is firmly inserted onto the
swivel shaft before use. Check the seat unit
is assembled properly by trying the height
adjustment function, following the instructions
All manuals and user guides at all-guides.com
in this user guide. If the height adjustment fails
to work, this means the seat unit is not properly
assembled, please re-try and press seat unit
downwards on the swivel shaft firmly in order
to properly engage the height adjustment
mechanisms.
a4
To move the baby chair across floor, first rotate
the seat unit so it is front facing, then engage
swivel resistor. Tilt the baby chair forward by
lifting on the handle located on the rear of the
seat unit, and then glide the highchair across
floor using the castor wheels, which are located
under the front end of the base.
• Continue to assemble the baby chair
• A child's safety is your responsibility.
Prevent serious injury or death from falls or
sliding out:
• Always secure child in the restraint.
• Never leave child unattended.
Section B: Cradle Mode
– suitable for 0 – 6 months (refer to
illustrations section b)
Lift & Glide – Easy Glide Wheels
WARNINGS:
according to the configuration suitable
for your child. Follow the corresponding
instructions carefully.
WARNINGS:
eng