Publicité
Les langues disponibles
Les langues disponibles
Energy saving tips
▪
The refrigerator should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
▪
Let hot foods cool to room temperature before placing in the refrigerator. Overloading the
refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose
quality, or spoil.
▪
Be sure to wrap foods properly, and wipe containers dry before placing them in the
refrigerator. This cuts down on frost build-up inside the refrigerator.
▪
Refrigerator storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the refrigerator less efficient.
▪
Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
Replacing light
This appliance consists of light-emitting diodes (LEDs). This type of
diode cannot be changed by the consumer. The lifetime of these
LEDs is normally sufficient for no change to be made. If however,
and despite all the care taken during the manufacture of your
appliance, the LEDs were defective, please contact your aftersales
service for any intervention.
ELECTRICAL INFORMATION
THIS APPLIANCE MUST BE EARTHED.
This appliance is fitted with a plug which will be suitable for use in all houses fitted with sockets to
current specifications.
If the fitted plug is not suitable for your socket outlets, it should be cut off and carefully disposed of.
To avoid a possible shock hazard, do not insert the discarded plug into a socket.
Door reversal instructions
Depending on your needs, you can change the opening side of the door. You can choose to
open it from the right or from the left. To change the opening side, follow the instructions.
Warning:
•
Before changing the opening side of the door, turn the appliance off and unplug it from the
mains.
•
Any removed part must be kept until the end of installation.
•
Do not lay the device down on the floor, you could damage the cooling system.
1. Power off the freezer and remove all objects from the door drawers.
2. Dismantle the hinge cover, screws and upper hinge, and remove the hole cap and pins
from the other side.
31
Publicité
