Replacing One Type Of Exhaust Filter With Another; When To Change The Thread Lifters; How To Replace The Thread Lifters; Cleaning The Roller On The Allteq Floorhead - Miele Swing H1 Mode D'emploi

Replacing one type of exhaust filter
with another
Depending on model, your vacuum
cleaner will be fitted as standard with
one of the following exhaust filters (dia.
28).
a AirClean
b Active AirClean (SF-AA 10)
c AirClean Plus (SF-H 10)
Do not use more than one exhaust fil-
ter at a time.
When changing the filter please note:
(dia. 34)
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that
you remove the filter grille from the
lid before you fit the new exhaust fil-
ter.
2. If you wish to replace exhaust filter b
or c with filter a, it is essential that
you also fit the filter grille * in the lid.
* Filter grille - see "Optional ac-
cessories".
To remove or insert the filter grille
(dia. 34)
 Grasp inside the hexagons in the filter
grille in the positions shown by the
arrows and squeeze slightly. The grille
can then be removed or inserted.

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters

(dia. 35)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Fit new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (dia. 36)
Clean the roller on the floorhead if re-
quired.
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.
en
41