Publicité
Les langues disponibles
Les langues disponibles
Care and maintenance
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
! Never use steam cleaners or pressure cleaners on
the appliance.
• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge which has been soaked in lukewarm
water and neutral soap. Use specialised products
for the removal of stubborn stains. After cleaning,
rinse well and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The hob grids, burner caps, flame spreader rings
and burners may be removed to make cleaning
easier; wash them in hot water and non-abrasive
detergent, making sure all burnt-on residue is
removed before drying them thoroughly.
• Clean the terminal part of the flame failure safety
devices* frequently.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
! Do not close the cover when the burners are alight
or when they are still hot.
All manuals and user guides at all-guides.com
Inspecting the oven seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
Authorised After-sales Service Centre. We
recommend that the oven is not used until the seals
have been replaced.
Gas tap maintenance
Over time, the tap may become jammed or difficult
to turn. If this occurs, the tap must be replaced.
! This procedure must be performed by a
qualified technician who has been authorised by
qualified technician who has been authorised by
qualified technician who has been authorised by
qualified technician who has been authorised by
qualified technician who has been authorised by
the manufacturer.
the manufacturer.
the manufacturer.
the manufacturer.
the manufacturer.
Replacing the oven light bulb
cap E 14.
3. Replace the lid and reconnect the oven to the
electricity supply.
Assistance
! Never use the services of an unauthorised
technician.
Please have the following information to hand:
• The type of problem encountered.
• The appliance model (Mod.).
• The serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
This procedure must be performed by a
This procedure must be performed by a
This procedure must be performed by a
This procedure must be performed by a
1. After disconnecting the
oven from the electricity
mains, remove the glass lid
covering the lamp socket ( see
figure ).
2. Unscrew the light bulb and
replace it with a similar one:
voltage 230 V, wattage 25 W,
GB
25
Publicité
