Ariston CP65SG1/HA Mode D'emploi page 17

hose must be used instead ( see below ).
Connecting a flexible jointless stainless steel
pipe to a threaded attachment
Make sure that the hose and gaskets comply
with current national legislation.
To begin using the hose, remove the hose holder
on the appliance (the gas supply inlet on the
appliance is a cylindrical threaded 1/2 gas male
attachment).
! Perform the connection in such a way that the
hose length does not exceed a maximum of 2
metres, making sure that the hose is not
compressed and does not come into contact with
moving parts.
Checking the tightness of the connection
When the installation process is complete, check
the hose fittings for leaks using a soapy solution.
Never use a flame.
Adapting to different types of gas
It is possible to adapt the appliance to a type of
gas other than the default type (this is indicated
on the rating label on the cover).
Adapting the hob
Replacing the nozzles for the hob burners:
1. Remove the hob grids and slide the burners
off their seats.
2. Unscrew the nozzles using a 7 mm socket
spanner ( see figure ), and replace them with
nozzles suited to the new
type of gas ( see Burner
and nozzle specifications
table ).
3. Replace all the
components by following
the above instructions in
reverse.
Adjusting the hob burners' minimum setting:
1. Turn the tap to the minimum position.
2. Remove the knob and adjust the regulatory
screw, which is positioned inside or next to the
tap pin, until the flame is small but steady.
! If the appliance is connected to natural gas, the
adjustment screw must be loosened in an
anticlockwise direction.
3. While the burner is alight, quickly change the
position of the knob from minimum to maximum
and vice versa several times, checking that the
flame is not extinguished.
All manuals and user guides at all-guides.com
! The hob burners do not require primary air
adjustment.
Adapting the oven
Replacing the oven burner nozzle:
1. Open the oven door fully.
Adjusting the gas oven burner's minimum
setting:
1. Light the burner ( see Start-up and Use ).
2. Turn the knob to the minimum position (MIN) after
it has been in the maximum position (MAX) for
approximately 10 minutes.
3. Remove the knob.
4. Tighten or loosen the adjustment screws on the
outside of the thermostat pin ( see figure ) until the
flame is small but steady.
! If the appliance is connected to natural gas, the
adjustment screw must be loosened in an
anticlockwise direction.
2. Remove the sliding oven
base ( see figure ).
3. Loosen the burner fixing
screws and take out the oven
burner after removing the
screw V.
V
4. Unscrew the nozzle using a
special nozzle socket spanner
( see figure ) or with a 7 mm
socket spanner, and replace it
with a new nozzle that is
suited to the new type of gas
( see Burner and nozzle
specifications table ).
GB
17