Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• The loop system is supplied ready for use with the following items
• Loop Amplifier with stand.
• Power Supply with lead and Mains lead with fitted plug.
• Digital audio optical TOSlink lead.
• Analogue audio lead kit : 1.2m phono – phono lead, SCART to RCA adaptor and
3.5mm stereo jack to RCA adaptor.
• 40m(130ft) Loop Cable and pack of 50 cable clips
• Guarantee Card
• User manual
Loop Amplifier
Place the amplifier in a convenient well ventilated area near to the TV or other audio source
such that all necessary connection leads can reach the relevant device. The optional stand
may be used to mount the amplifier vertically if required..
Place Loop Cable around listening area
Run the loop cable around the room starting and ending at the amplifier.
The cable may be tucked under the edge of the carpet, or fixed to either
a picture / dado rail or skirting board with the clips provided. Where the
cable passes a door or other obstacle, either fix the cable around the
frame or tuck under the carpet. The cable only has to go round the area
to be looped, it does not matter about going up and over doors/windows
or round fireplaces etc.
Excess loop wire may be cut off, provided a MINIMUM of 11 metres (35 feet) is left
connected to the amplifier. DO NOT leave spare cable coiled on the drum.
If using a Loop Pad
Place the loop pad (available as accessory) in a suitable position on the chair to be used for
listening, either on the chair back or under the seating area. Lay the connecting lead from the
Pad to the back of the Amplifier. Make sure that the connecting lead is kept out of the way to
prevent injury or obstruction.
Setting Up
English 15
Publicité
Table des Matières
