Moulinex JU585H Mode D'emploi page 5

BEFORE FIRST USE
• We recommend that you wash all the removable parts (A, B,C, D, E, G, L, M, N) in
warm soapy water (see paragraph "Cleaning"). Rinse and dry them carefully.
• Unpack the appliance and place it on a solid, stable work surface.
• Ensure that all packaging has been removed before starting the appliance.
USING THE APPLIANCE
• Fit the juice collector (E) in the appliance, tipping it slightly forward to pass the
pouring spout through the hole provided (see Fig. 1).
• Place the sieve (D) in the juice collector (E). Ensure that the sieve is properly
clipped onto the drive shaft (J). You can hear an audible click when the sieve is
positioned correctly (see Fig. 2).
• Fit the cover (C) on the appliance, ejection spout to the rear (see Fig. 3).
• Push the safety clamp (H) to the rear until it locks into place. You will hear an
audible "click" (see Fig. 4).
• Fit the pulp collector (G) on the rear of the appliance (see Fig. 5).
• Slide the pusher (A) into the feed tube (B) aligning the groove on the pusher with
the small ridge in the feed tube.
• If you wish to separate the juice from the froth, slide the foam separator (M) in the
juice jug (N) and fit the cover onto the jug (see Fig. 6). The foam separator allows
you to keep the froth inside the jug when you pour the juice into a glass.
• This appliance is fitted with a drip-stop system (F): push the pouring spout down to
actuate the system and allow the juice to flow out (see Fig. 7)
• Place the juice jug (N) under the pouring spout in front of the appliance (see Fig.
8).
• Plug in the appliance.
• To start the appliance, use the control switch (I).
• Insert the fruits or vegetables through the feed tube (B).
• The fruits and vegetables must be inserted only while the motor is running.
• Do not press too hard on the pusher (A). Do not use any other utensil. NEVER push
with your fingers.
• When you have finished, stop the appliance by turning the control switch (I) to 0
and wait until the sieve (D) stops completely.
• When the pulp collector (G) is full, or the juice flow slows down, empty the pulp
collector and clean the sieve and the cover.
• After making your juice, activate the drip-stop system by pushing the pouring spout
up before removing your glass to stop the flow of the juice (see Fig. 9).
All manuals and user guides at all-guides.com
5
• To remove the filter, release it by pulling hard with both hands (see Fig. 10 and 11).
WHICH SPEED TO USE?
Ingredients Speed
Apples 2
Pears 2
Carrots 2
Cucumbers 1
Pineapple 2
Grapes 1
Tomatoes 1
Celery 2
Choosing the wrong speed may cause the appliance to vibrate abnormally.
It is recommended that you use the appliance for no more than 2 minutes
continuously.
*
The quality and quantity of juice varies greatly according to the date of harvest and the particular variety of fruit
or vegetable. The quantities of juice indicated above are therefore approximate.
PRACTICAL TIPS
• Wash the fruit carefully before stoning.
• In general, you do not need to remove the skin or peel. You only need to peel
fruit with thick and bitter skin, like lemon, orange, grapefruit or pineapple
(remove the centre stalk).
• Certain types of fruit like apples, pears, tomatoes etc. (with a diameter less than
74 mm) will fit in the feed tube whole, thanks to the "Direct Fruit System". So
choose the appropriate type of fruit or vegetable.
• It is difficult to extract juice from bananas, avocados, blackberries, figs,
aubergines and strawberries.
• The juice machine should not be used for sugar cane and excessively hard or
fibrous fruit.
• Choose fresh, ripe fruit and vegetables, they will yield more juice This appliance
is suitable for such fruits as apples, pears, oranges, grapes, pomegranates and
pineapple and such vegetables as carrots, cucumbers, tomatoes, beetroot and
celery.
• If you use over-ripe fruit, the sieve will be blocked more quickly.
Quantity of juice
Approx. weight (in kg)
obtained in ml (*)
1 650
1 600
1 600
1 (about 2 cucumbers) 600
1 300
1 450
1,5 900
1,5 350
6