Publicité
1.
Unit of measurement
Press the button
to display the desired unit of measurement (METRIC = kilometres / ENGLISH = miles).
2.
Screen contrast
Press the incline adjustment buttons to adjust the contrast.
3.
The demo mode is designed to be used when the treadmill is displayed in store. It allows the screen to remain in operation when the safety
key has been removed from the console (automatic presentation of diferent programs).
Press the button
to activate or deactivate the demonstration mode.
4.
Display of the total time (in hours) and the distance run (in miles or kilometres depending on the unit of measure chosen) since the treadmill
was irst started up.
Remove the safety key from the console.
Regular maintenance is necessary to maintain the performance of the machine and to extend the life of the product. Refer to the maintenance
table at the end of the instructions.
Failure to comply with maintenance recommendations may result in premature wear, permanent damage and voiding of the guarantee.
If you have any questions, please contact your local DECATHLON store or visit our website, www.domyos.com.
1. Tighten the screws and bolts once a month.
2. Lubricate the running belt after 20 hours of use. Process described below: "Lubrication of the running belt."
3. Place a suitable loor mat (such as the Domyos Training Mat) under your treadmill.
Switch of and then unplug the treadmill.
Apply a small amount of mild, multi-purpose cleaner, using a 100% cotton cloth. Do not spray directly onto the walking belt
and do not use acid or ammonia-based cleaning products.
Wipe the console and screens.
Remove any dust and grime from the hand rails, uprights, foot rails, frame and motor hood. In addition, wipe the deck along
the sides of the walking belt. Do not wipe under the walking belt.
The space G between the walking belt and the foot rails must be visible at all times on both sides of the belt. This prevents damage
to the walking belt and untimely stopping.
G
G
Run your treadmill at 5 km/h (3 mph) and stand behind
the machine.
Turn the left adjusting screw clockwise half a turn.
Turn the right adjusting screw clockwise half a turn.
Let the treadmill run long enough for the belt to reposition
itself (1-2 minutes) and repeat the procedure if necessary.
However, make sure that the belt is not too tight.
Publicité
