Descaling - SEVERIN Fino Latte KA4565 Mode D'emploi

Fino Latte KA4565

5.2 Descaling

34
If the display element (H.1)
process, the appliance requires descaling.
Commercially available products for descaling of coffee makers are suitable
for this purpose. Prepare a batch of 900ml of the descaling liquid in
accordance with the instructions of the manufacturer of the descaling agent.
Important: Do not use vinegar or descaling agents on the basis of
acetic acid as there is a risk of damaging the appliance, e.g. at the
gaskets!
Please note: The safety information of the manufacturer of the
descaling agent must be observed. Do not pour the descaling agents
into enamelled sinks.
1. Fill the descaling liquid into the water reservoir (L) up to the mark MAX
(approx. 900ml).
2. Open brewing unit (A). For this purpose, fully fold the bracket closure (B)
upwards.
3. Remove the strainer support from the brewing unit.
4. Use a tall container with a capacity of minimum 900ml (e.g. a measuring
jug for 1l) and place it onto the drainage grille (G) without the drip tray
(F).
5. Press the Start/Stop button (H.3)
lights up. The descaling process is started and the display element
(H.1) starts flashing. The container is filled in intervals until the water
reservoir is empty. The appliance will stop between the individual
intervals (for approx. 30 seconds).
6. When the water reservoir is empty the display element (H.2)
flashing. The rinsing process can be started. For this purpose, remove
the water reservoir (L), rinse it under running water and fill it up with
fresh, cold water up to the mark MAX (approx. 900ml). Empty the used
descaling liquid from the tall container and place the container back
onto the drainage grille. Now, press the Start/Stop button (H.3)
display element (H.2)
cold water until the water reservoir is empty.
7. Now the appliance is descaled and ready for operation.
flashes quickly during the preparation
until the display element (H.2)
lights up again and the appliance is rinsed with
starts
. The