Milk Froth - SEVERIN Fino Latte KA4565 Mode D'emploi

Fino Latte KA4565

3.2 Milk froth

A
28
Advice: The milk should be well cooled. Warm milk is not good for
frothing. Use - as you like - milk with a fat content of up to 3.5%.
Important: Please clean the strainer support for the milk (D) carefully
after every use in order to avoid the formation of milk bacteria and to
ensure the function of the strainer support.
1. Assemble the strainer support for the milk (D).
– Put the milk pipe (D.1) into the strainer support (D).
– Put the valve (D.2) with the tube into the milk pipe (D.1).
Note: To generate milk froth, the valve (D.2) must be open, see figure.
2.
The nose at the milk pipe (D.1) must fit with the nose at the valve (D.2).
3. Now, open brewing unit (A). For this purpose, fully fold open the bracket
closure (B) and insert the strainer support (D).
4. Close the brewing unit (A) by firmly pressing the bracket closure (B)
downwards.
5. Put a high glass, a mug or another suitable container onto the drainage
grille (G) and plunge the tube (D.3) into the milk container.
6. Now press shortly the Start/Stop button (H.3)
process is started (display element (H.1)
heat-up phase the cup is filled with milk froth.
7. Please wait until your appliance has completed the follow-up time, i.e.
the display element (H.1)
generated.
8. Then, remove your cup, fold the bracket closure upwards and remove
the strainer support from the appliance for cleaning.
9. Ready! Now enjoy your milk froth or use it to prepare different types of
mix drinks.
Advice: For an easier cleaning submerge the tube (D.3) directly after
preparation into a container with hot water. Put a suitable container under
the outlet. Then start the operation by pressing the Start/Stop key (H.3)
Thus, the strainer support for milk is cleaned quickly and simply.
. The preparation
is flashing). After a short
stops flashing. A short acoustic signal is
.