Assembly; Assemb Ling The Stand - Dms 160 A/At; Assembling The Stand - Dms 160 Gyro - Husqvarna DMS 160 A Manuel D'utilisation

Assembling the stand - DMS 160 A/
AT
DMS 160A
DMS 160 A/AT
• Drill holes (15 mm) in the floor or in the wall and knock in
the expander bolts.
• Bolt down the base plate. Check carefully that the
expander is secured correctly.
DMS 160 AT
• The drill column is mounted on the base plate´s angle
bracket. Tighten the lock screw with an 8 mm allen key.
The drill column can be turned through 360° and locked
variably in each position using a locking screw (8 mm allen
key)
• The drill column is set at the required angle by tightening
the nut using a 24 mm spanner. If the vacuum plate is
used, make sure the support surface is not porous and
can loosen. Make sure that the vacuum pump has
sufficient power to secure the vacuum plate. A suitable
vacuum motor is Husqvarna VP200.
WARNING! The vacuum plate must never be
!
used for ceiling drilling. Careless or
incorrect use can result in serious or fatal
injury to the operator or others.

ASSEMBLY

DMS 160 AT

Assembling the stand - DMS 160 Gyro

2
1
5
6
9
DMS 160 Gyro
3
4
7
8
10
11
– 9
English