Tivoli Audio NetWorks Manuel D'utilisation page 18

All manuals and user guides at all-guides.com
English
The Display:
The display's backlight and display LCD contrast are controlled automatically via a small sensor
in the lower right corner of the front panel. There are no manual adjustments other than turning
the display off whenever the NetWorks is turned off. This option is found in the main menu under
"Settings". If selected, the display will go dark after the NetWorks is turned off. This might be useful
when using the NetWorks as an alarm clock in a bedroom and complete darkness is desired. The
display will return to normal when the NetWorks is powered on again, the alarm sounds, or the snooze
countdown is active. With the unit off, while the display is dark, press any button on the remote
control (except Power or Alarm) to turn the display on for 5 seconds. This will allow you to see the
time without having to turn the radio on and off again. With the unit off, press any button on the
remote two times and the display will turn on or off without having to turn the NetWorks on and
accessing the main menu. Note: The display can be affected by hot and cold temperatures.
Placement:
Place the NetWorks on a flat, stable surface. The NetWorks' driver is shielded and may be used
in close proximity to a computer monitor or television set. Do not obstruct the rear bass port.
Placement in a bookcase, corner, or against a wall will inflate the bass.
Cleaning:
Never use any harsh cleansers or solvents on the NetWorks cabinet or plastic panels, as this
could damage the finish.
NOTE: Tivoli Audio cabinets use real wood veneers. Since natural wood varies greatly, it is not
possible to achieve an exact wood color/grain match between models. You may also notice
the wood darken over time with exposure to sunlight. Again, this is normal for real wood.
TROUBLESHOOTING:
If you are unable to get the NetWorks radio to connect to your WiFi network and you have a PC,
confirm your PC can connect to your WiFi network to verify it is operational.
Check that your network doesn't restrict connections to particular MAC addresses. View the
NetWorks' MAC address in the main menu under "Info", shown as "Radio ID".
Check that a DHCP server is available, or that you configured a static IP address on the NetWorks.
You can configure a static IP address on the NetWorks in the main menu under "IR Set Up".
Check that your network's firewall isn't blocking any outgoing ports.
If using an Ethernet cable, be sure the cable is fully inserted into the NetWorks Ethernet jack and
you've selected "Wired" under "Manual settings" in "Internet Setup".
In the rare event you encounter an operational problem, unplug the NetWorks for a few seconds
and plug it back in. If this fails to cure the problem, try the factory re-set.
18