Tivoli Audio NetWorks Manuel D'utilisation page 15

password (if applicable), EQ settings, and any other customized settings. In the rare event you
encounter an operational problem, unplug the NetWorks for a few seconds and plug it back in.
If this fails to cure the problem, try the factory re-set.
11. Info (found under "Settings"): This shows information about your NetWorks radio which you
might be asked to provide should you phone or email with questions about software or repair.
This differs from the Info button on the remote control.
12. Software Upgrade (found in the main menu under "Internet Setup" in Internet radio
mode only): A message will appear automatically in Internet radio mode advising you when
new software is available. Otherwise, to check to see if an upgrade is available, access the
"Internet Setup" in the main menu in Internet radio mode and select "Software Upgrade". It is
recommended you check for a software upgrade after completing initial set-up of your NetWorks
to be sure its software is fully up-to-date. Several different upgrades might be necessary.
The NetWorks will automatically re-boot after a successful upgrade. In the unlikely event you
experience any odd behavior after a software upgrade, perform a factory reset.
WARNING: It is vital the NetWorks not be powered off or unplugged during the software
upgrade process or else the radio will require servicing to restore operation.
How to set the Alarm:
1. Press the Alarm button on the remote or enter the "Alarm" menu under "Settings". The Alarm
button on the remote will access the alarm menu even when the NetWorks is off.
2. Select Alarm 1 or 2.
3. Select "Time". Adjust the hours with the pq buttons and press Select to save and repeat
the process for the minutes. You will see a message confirming the alarm time and alarm has
been set.
4. Select the same alarm again to change the other options such as to set the alarm on or off,
Schedule (whether you want the alarm to sound every day ("Daily") at the set time, or only on
weekdays, only on weekends, or just once); the source you wish to wake to, the volume level of
the alarm (set by the pq buttons not the Volume buttons), and select "Save" to store the changes.
Note: You must select "Save" after making any changes or else the changes will not
be saved in memory.
5. If you access the alarm menu while the NetWorks is off, once you've finished making and
saving you're adjustments, press the alarm button again or the Left arrow button (t ) to return
the NetWorks to off mode.
Alarm Quick Set: If you don't need to change any settings in the alarm menu and just want to set
the alarm to wake, press and hold the Alarm button on the remote control to set Alarm 1. Press
and hold again to set Alarm. 2. Press and hold again to set both Alarm 1 and 2. Or press and hold
a fourth time to cancel both alarms.
During a power outage, the alarm time(s) and clock will be maintained by an integrated back-up
memory. However, if power is lost during the same time the alarm is set to activate, the alarm
cannot activate.
If you wish to wake to an Internet station, be sure the station is broadcasting during the time the
alarm is set to activate. If waking to an Internet radio station that is unavailable or takes too long
to load, the alarm will default to the tone as a back-up. If waking to an Internet station and there
All manuals and user guides at all-guides.com
English
15