Publicité
Les langues disponibles
Les langues disponibles
BEFORE INSTALLING THE HOOD
▪
For the most efficient airflow exhaust, use a straight run or as few elbows as possible.
▪
Vent unit to the OUTSIDE only.
▪
At least two people are required for installation.
▪
Remove the range hood from the carton packaging and place on a flat surface for assembly.
CAUTION
THIS APPLIANCE SHOULD BE PROPERLY GROUNDED.
▪
This hood has two types of electrical connection:
▪ A connection with electric wires
▪ 3-wire power outlet, 120V 60Hz (supplied but not installed).
▪
Make sure the unit is connected to an individual, properly grounded circuit.
▪
If the electrical supply does not meet above requirements, call a licensed
electrician before proceeding.
▪
Route house wiring as close as possible to the installation location, in the ceiling or back wall.
▪
The hood must be connected to the house wiring in accordance with the local codes and norms.
WALL FRAMING FOR ADEQUATE SUPPORT
THIS VENT HOOD IS HEAVY. ADEQUATE STRUCTURE AND SUPPORT MUST BE PROVIDED IN ALL TYPES
OF INSTALLATION. IF MOUNTING ONTO DRY WALL, IT IS RECOMMENDED THAT THE HOOD BE SECURED
TO VERTICAL STUDS IN THE WALL OR TO A HORIZONTAL SUPPORT.
WARNING
BE CAREFUL WHEN INSTALLING THE HOOD, AS IT MAY HAVE SHARP EDGES. WE RECOMMEND THAT YOU
WEAR PROTECTIVE GLOVES.
CAUTION
DO NOT REMOVE THE PROTECTIVE PLASTIC FILM COVERING THE HOOD AT THIS STAGE.
7
Publicité
