Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
SAFETY WARNING: NEVER PUT YOUR HAND INTO AREA HOUSING THE FAN
For optimal operation, clean range hood and filters regularly. Regular care will help preserve the
appearance of the range hood.
CLEANING THE SURFACES
Clean periodically with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent
or steel wool pads, which will scratch and damage the stainless-steel finish. For heavier soil, use a liquid
degreasing cleaner. Use a stainless-steel cleaner to clean the surfaces of the hood. Avoid getting cleaning
solution onto or into the control panel. Follow directions of the stainless-steel cleaner.
CAUTION
USE SOFT TOWEL TO WIPE OFF THE CLEANING SOLUTION, GENTLY RUB OFF ANY STUBBORN SPOTS. USE DRY SOFT
TOWEL TO DRY THE HOOD. ALWAYS SCRUB LIGHTLY WITH CLEAN COTTON CLOTH AND IN THE DIRECTION OF THE
GRAIN.
DO NOT ALLOW DEPOSITS TO ACCUMULATE OR REMAIN ON THE HOOD. DO NOT USE ORDINARY STEEL WOOL OR
STEEL BRUSHES. SMALL BITS OF STEEL MAY ADHERE TO THE SURFACE AND CAUSE RUSTING.
DO NOT ALLOW SALT SOLUTIONS, DISINFECTANTS, BLEACHES OR CLEANING COMPOUNDS TO REMAIN IN
CONTACT WITH STAINLESS STEEL FOR EXTENDED PERIODS. MANY OF THESE COMPOUNDS CONTAIN CHEMICALS,
WHICH MAY BE HARMFUL. RINSE WITH WATER AND WIPE DRY WITH A CLEAN CLOTH.
CLEANING THE GREASE FILTER
The filters are intended to filter out residue and grease from cooking and are required to be kept clean.
Filters should be cleaned after every 30 hours of use (or once a month, depending on use). Remove and
clean by hand in soapy water or in the dishwasher. Dry filters and re-install. If cleaning the filters in the
dishwasher, use a non- phosphate detergent. The use of detergent with phosphate may cause
discoloration of the filters, but will not affect their performance. This discoloration is not covered by the
warranty.
REPLACING THE FILTERS
If filters wear out due to prolonged use, please contact your service/parts provider for replacement filters.
NOTE:
ALSO REPLACE DAMAGED FILTER THAT HAS PUNCTURED OR BROKEN MESH, BENT OR BROKEN FRAME.
CLEANING THE STAINLESS-STEEL SURFACES
Regularly wash surfaces with dry cloth or clean cloth soaked in warm water and mild soap or liquid dish
detergent. Always clean following the grain. Always rinse thoroughly with clear water (2-3 times) and wipe
dry completely. Specially designed stainless-steel cleaners can also be used.
REPLACING THE LED LIGHT BULBS
Cut the power supply by turning the hood off. Wait for the LED lamps to cool. To prevent damage or to
avoid reducing the life of the new bulb, do not touch the bulb with your bare fingers. Replace the bulb by
manipulating with a tissue paper or cotton gloves.
If the new lights do not work, ensure that each lamp is properly inserted into its socket before requesting
the intervention of a service agent.
15
Publicité
