Signature CUVEE S31N Manuel D'utilisation page 51

Disassembly and assembly the lamp of upper zone
Instructions:
1. Use a screwdriver to remove a tapping screw in the view (1).
2. Pull out the lampshade to the left by hand. See view(2).
3. Use a screwdriver to remove two tapping screws (3) of the fixed LED lamp
panel (4), remove the LED lamp panel and replace it with a new LED lamp
panel, and then reinstall the two screw.
4. Insert the newly removed lamp panel to the right into the slot of the lamp box
(5) and secure the screws on the left side.
LAMP REPLACEMENT
（5）
（4）
（3）
（2）
（1）
EN-19