cecotec ThermoSense 290 Steel Manuel D'instructions page 9

All manuals and user guides at all-guides.com
- To avoid scalding, always ensure the lid is correctly positioned before operation.
- Scalding may occur if the lid is removed while heating.
- Remove and replace the lid carefully when hot.
WARNING: you must be extremely cautious when moving the kettle containing hot water. Never lift the kettle
by its lid. Always use the body handle.
• Never switch on your kettle when its empty.
• Do not use the base unit for other purposes.
• To avoid the steam scalding your hands, do not open the lid while water is boiling or in the short time
before and after.
WARNING: please avoid the liquid sprinkle in the LED board and the pressed key place in the operating process.
The water may cause damage to the display.
3. BEFORE USE
Before use the machine for the first time, water should be boiled in it twice without any additives. Discard the water after.
• The kettle should always be unplugged when filling or adding water.
• Fill the kettle with water to desired level. Do not overfill. Use the water level indicator. You can fill via the
spout or opening the lid.
WARNING: do not forget to close the lid properly after filling, otherwise the kettle will not automatically stop
after boiling.
• Do not fill with less than 0.5 L of water. Always from the MIN. mark to prevent the kettle running dry while operating.
• Do not fill with more than 1.7 L of water. Always to the MAX. indicator.
• An automatic safety system has been installed for protection against overheating. It will be efficient if the
kettle is switched on with insufficient water. If the safety system activates, disconnect the from the power
outlet and allow the kettle to cool down for 5 or 10 minutes.Refill the kettle and it will work normally.
• After boiling the machine switches off automatically.
• Disconnect the kettle from the power supply.
• Do not open the lid when pouring.
• If the kettle is overfilled, boiling water may be ejected.
4. OPERATION
Put the base on a dry, plane and stable surface, insert the plug to a safe power supply. You must boil water two
times and then discard this water. Your kettle is now ready to use.
1. Press the button, you will hear a sound and the product will start running. The water will boil, the
indicator will turn off and you will hear a sound at the same time.
2. Press for 3 seconds, you will hear a sound and it's ready to use. The red LED light is on and after a
while the water will boil, the kettle will keep its temperature for 2 hours with the red light twinkling. The
kettle is in insulation mode. During this period of time, if the temperature drops to less than 85°C, the
kettle will heat to keep it warmer.
3. Press button once and shortly, you will hear a sound then the kettle is under the boiling point mode.
• Press one time, the indicator LED light is green. This means that the kettle will stop heating
when temperature reaches 60ºC.
• Press two time, the indicator LED light is blue, this means that the kettle will stop heating when
temperature reaches 70ºC.
• Press three times, the indicator LED is yellow, this means that the kettle will stop heating when
temperature reaches 80ºC.
ENGLISH
THERMOSENSE 290 STEEL 9