Neuton CE 5.2 Consignes De Sécurité Et D'utilisation page 46

ALWAYS REMOVE THE SAFETY KEY AND BATTERY BEFORE PERFORMING ANY ADJUSTMENTS,
MAINTENANCE, OR REPAIRS TO YOUR MOWER.
P C
ROBLEM
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery,
The Mower runs,
but the cutting
performance is ⇒ The Blade may be dull, bent, loose or damaged. Remove the Safety Key and the
unsatisfactory, or
there is a loss of
power.
⇒
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting
The Mower is hard
to push.
⇒ The Wheels may not be rotating freely. Remove the Safety Key and the Battery,
⇒ The Battery was probably not at full charge prior to Mowing. Charge the Battery,
The Battery loses its
charge quickly.
NOTE: You will need to charge a new Battery at least five (5) times to achieve maximum
⇒ The grass may be too high or too thick for the cutting height. Raise the cutting
⇒ The Battery may be getting old. After some time, usually about five (5) years, you
⇒ The rear Bagger is full. Empty the Bagger, and clean it if necessary.
The Mower rear
⇒ The grass is too long or the Mower is cutting too low. Raise the cutting height.
Bagger is collecting
grass poorly.
⇒ The Mower is moving too fast, slow down.
⇒ The mesh holes in the rear Bagger are clogged, clean them out.
⇒ The rear Bagger is wet. Allow it to dry thoroughly before using it again.
42
All manuals and user guides at all-guides.com
A
ORRECTIVE CTION
if necessary.
Battery, turn the Mower over, and check the condition of the Blade. Sharpen,
tighten, or replace the Blade, if necessary.
The grass may be too high or too thick for the cutting height. Raise the cutting
height or narrow your cutting swath and try again.
height or narrow your cutting swath and try again.
turn the Mower over, and check the Wheels for damage.
if necessary.
cutting time.
height or narrow your cutting swath and try again.
will need to replace the Battery.
1-866-NEUTON1 (638-8661) www.neutonowners.com