Neuton CE 5.2 Consignes De Sécurité Et D'utilisation page 17

Les langues disponibles

2. Position the Lower Handlebar with the smooth side against the frame of the Mower. Slide it down

fully into the slot on the frame until the holes line up (Figure 5).

NOTE 1: Place the Lower Handlebar with the cord clip on the right side (viewed from the Operator's position

behind the Handlebar) of the Mower.

NOTE 2: Be sure you slide the Handlebar all the way down to the bottom of the slot. When you do this, the

cutout notch on the end of the Handlebar aligns with the base of the channel in the Mower's frame.

3. Insert a green Quick-Connect Knob with a Lock Washer through the lined-up holes on the

Handlebar and Mower frame (Figure 6). Turn the Knob clockwise until firmly snug. Repeat this

step for the other side.

Figure 5

BE SURE TO TIGHTEN THE GREEN QUICK-CONNECT KNOBS BY HAND. DO NOT USE A TOOL TO TIGHTEN

THEM; YOU COULD EASILY OVER TIGHTEN THEM AND DAMAGE THE PARTS.

Step 5: Attach the Upper Handlebar Assembly

NOTE: You will use the black Connector Knobs and

Bolts (already attached to the Lower

Handlebars) to connect the Upper and

Lower Handlebar sections together.

1. Remove the black Connector Knobs and

Connector Bolts from the upper ends of the

Lower Handlebars.

TIP

Let the Upper Handlebar Assembly lean on the

ground during this process (Figure 7). It is easier

to start with the Upper Assembly in this position,

so you don't have to hold and balance it while

connecting the sections. Once you have the

Handlebars loosely connected, you can swing

the Upper Assembly into place and tighten it

further (Figure 8) on page 14.

NEUTON CE 5.2 Battery-Powered Mower -

All manuals and user guides at all-guides.com

Holes aligned

Safety & Operating Instructions

Lock Washer

Figure 6

Upper Handlebar in a position

for ease of attachment.

(shown already attached)

Figure 7

Green Quick-

Connect Knob