Publicité
Les langues disponibles
Les langues disponibles
1. Walk through the coverage area noting
where you are when the lights turn on.
Loosen the 3 clamp screws slightly and
turn the sensor head left or right to change
the coverage area.
2. When you have the desired coverage
angle make a pencil mark on the sensor
and post to mark the sensor position.
3. If you need to change the sensitivity, tem-
porarily lift the fixture and sensor to make
the adjustment. It may be necessary to
have a friend hold the fixture while adjust-
ing the sensitivity. Too much sensitivity may
increase false triggering.
4. Set the amount of TIME you want the
light to stay on
after motion is
detected. (1, 5, or
20 minutes).
5. Set the D
B
®
ual
rite
(ACCENT) switch
to the amount of
time after dusk you
want the lights on
at low level (Off,
3, 6 Hrs., Dusk-to-
Dawn).
SYMPTOM
POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turnoff is in effect (Recheck
after dark).
5. Incorrect circuit wiring, if this is a new
installation.
6. Re-aim the sensor to cover desired
area.
Light comes
1. Light control may be installed in a
on in daylight.
relatively dark location.
2. Light control is in Test. (Set control
switch to an ON-TIME position).
Light comes
1. Light control may be sensing small
on for no ap-
animals or automobile traffic (Re-aim
parent reason.
sensor).
2. Sensitivity is set too high. (Reduce
sensitivity).
ON-TIME
MINUTES
20
5
1
TEST
ACCENT
DUSK TO DAWN
6 HOUR
3 HOUR
OFF
TROUBLESHOOTING GUIDE
6 Put the sensor and fixture back in place.
Align the pencil marks made above.
Tighten the three screws to secure the
sensor.
SECURING BRASS AND
PLASTIC POST LAMPS
WARNING: Turn power off at circuit
breaker or fuse.
1. Turn the post lamp to the desired loca-
tion. Using a #31 drill and the fixture as a
template slightly mark the location of one
of the fixture mounting holes. DO NOT drill
through the sensor plastic.
2. Lift the fixture off the sensor and keep the
wires away from where you need to drill.
Now finish drilling the first hole.
3. Set the fixture in position and install a
screw (provided) to hold the fixture.
4. Mark the remaining holes as above.
5. Remove the one screw and lift the fixture
and drill the remaining holes as above.
6. Set the fixture in position and install all
the screws (3 provided). Be careful to not
over tighten the screws and strip out the
plastic.
SYMPTOM
POSSIBLE CAUSE
Light stays on
1. The sensor is pointed at nearby
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Reduce
Light flashes on
1. Heat being reflected from other
and off.
2. Light control is in the Test mode and
4
objects that cause heat to trigger
the sensor. (Aim the sensor away
from nearby objects).
(Switch to Auto.)
ual
mode.
sensitivity.)
objects may be affecting the sensor.
(Re-aim sensor).
warming up. (Flashing is normal
under these conditions).
595-5657-04
B
®
rite
Publicité
