Publicité
Les langues disponibles
Les langues disponibles
Operation
14
16
11
15
16a
D
16b
17
7
27
8
15
16
12
23
22
24
21
20
13
28
27
19A
14
19
8
B
18
29
A
25
C
86452440 Manual Ranger 12 120V 60Hz
Connecting and Operating Elements
11. Zipper
12. Sliders
13. Connecting device
14. Handle tube
15. Handle
16. Handle guide (two parts that snap together)
17. Lower Bearing guide
18. Rotating cable hook
20. On / Off-Switch
21. Height adjustment Brush
22. Bearing block right hand
23. Release button bearing block
24. Foot pedal
25. Filter bag connection
26. Brush roller
27. Mains Connector
28. Sealing Adapter
Assembly & Cable Installation
Insert the handle tube (14) into the grip (15), so that
the drilling (19A) in tube becomes visible through the
hole (19) in the handle (15). Secure this connection
with the M4x10 screw (8) out of the screw kit (6).
Please Note: The dust bag housing cover cannot be
removed completely!
illustrations only to improve clarity!
Open the flap (29) (as shown in Step A) in the lower
part of the shaft guide (16b). This flap can be
unlocked with the latch on 16b from inner side of the
filter housing.
Guide the power cord through the upper part of the
shaft guide (16a) as indicated by the dash-dot line
(Step B).
Loosely route the power cord cable to the mains
connector (27) at the bottom of the filter housing
(Step C).
Then the upper guide (16a) and lower guide (16b)
parts, assembled as shown can be locked together
(Step D).
The handle assembly then has to be inserted into the
lower part of the bearing guide (17) (already
assembled with the filter bag housing) and will be
secured with the two remaining M5x30 screws (7).
It has been omitted in the
Publicité
