Publicité
Les langues disponibles
Les langues disponibles
Before you call for service...
Problem
Possible Causes
Dishes and flatware
Low inlet water temperature
not clean
Water pressure is temporarily low
Air gap is clogged
Improper rack loading
No air gap or high drain loop
Filter needs cleaning
Spots and filming
Extremely hard water
on glasses and
flatware
Low inlet water temperature
Overloading the dishwasher /
Improper loading
Old or damp powder detergent
Rinse agent dispenser empty
Too little detergent
Cloudiness on
Combination of soft water and
glassware
too much detergent
Water temperature entering
the dishwasher exceeds 65°C (150°F)
Black or gray
Aluminum utensils have
marks on dishes
rubbed against dishes
Yellow or brown film
Tea or coffee stains
on inside surfaces
An overall yellow or brown film can
be caused by iron deposits in water
White film on inside
Hard water minerals
surfaces
Dishes don't dry
Low inlet water temperature
Rinse agent dispenser is empty
Control panel
Door latch may not be
responded to input
properly seated
but dishwasher never
Water vale may be
filled with water
turned off
Dishwasher beeps
This is normal
once every
60
seconds
This is a reminder that the
door has been left open
during operation
All manuals and user guides at all-guides.com
What To Do
If so, wait until pressure is normal before using your dishwasher.
dispenser or the wash arms.
Installation Instructions.
efficiently remove food particles from the wash water. See Cleaning the
Filter section on page 1.
prevent new film buildup.
Make sure water temperature is at least 49°C (120°F).
Load dishwasher as shown in the Loading the Dishwasher Racks
section.
Make sure detergent is fresh.
If water is extremely hard, a water softener may be required.
use less detergent if you have soft water. Wash glassware in the shortest
cycle that will get them clean.
Lower the water heater temperature.
3 cups warm water.
Before cleaning interior wait at least 20 minutes after a cycle for the
heating element to cool down. Failure to do so can result in burns.
this problem. Contact a water softener company.
Wear rubber gloves. Do not use any type of cleanser other than
dishwasher detergent because it may cause foaming or sudsing.
Make sure inlet water temperature is correct (see page 6).
Check the rinse agent dispenser.
rinse agent to remove spots and
WARNING
ON/OFF to turn OFF the dishwasher.
13
Publicité
