Publicité
Les langues disponibles
Les langues disponibles
PRODUCT OPERATION
Using the Swash: Getting Started
NOTE: The seat has a built-in skin
conductivity sensor. The wash functions
will not work unless the sensor detects
someone is seated. To override the seat
sensor, see instructions on page 23.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact
on the seat sensor.
Warm Water Wash
When ready to wash, press the Rear Wash,
Front Wash, or Strong Wash button on the
remote control once to initiate a wash. The
nozzle will perform a self-cleaning rinse,
extend into the toilet bowl, spray for 2 minutes,
turn off automatically, retract, and self-clean
once again.
1. To activate the move function during a
wash, press the Rear Wash, Front Wash,
or Strong Wash button a second time. This
will initiate the nozzle to oscillate forward
and backward, providing a wider wash
spray range. Press again to stop the move
function.
2. While washing, users can adjust the water
temperature, pressure, and nozzle position
settings. See page 17 for details.
3. To stop the wash before the 2-minute cycle
ends, press the Stop button to discontinue
water flow.
Warm Air Dryer Function
Press the Dry button to activate the warm air
dryer. The dryer will run for 2 minutes and turn
off automatically.
1. While the air dryer is operating, users
can adjust the dryer temperature to a
comfortable level using the Dry Temp
+ and – button on the right side of the
remote control. The dry temperature will be
reflected on the 5 LED indicator lights.
2. To stop the dryer before the 2-minute cycle
ends, press the Stop button.
Gentle Wash
Auto settings within the gentle wash mode are
40% softer than standard wash modes. Gentle
wash will begin a wash that includes:
• full nozzle extension
• water pressure set to level 2
• front wash and oscillation for 1.5 minutes
• warm air dry cycle for 2-minutes set
on level 2
NOTE: During a gentle wash cycle, water
pressure and dryer settings may still be
adjusted.
19
Publicité
