Preparation For Installation - Kinderkraft Expander ECE II + III Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
● The seat cover should not be replaced with any other than the one recommended by the
manufacturer, because the cover constitutes an integral part of the restraint
performance.
● The Instructions can be retained with the child seat for its life period.
● Not to use any load bearing contact points other than those described in the instruction
and marked on the child car seat.
● Any rigid items and plastic parts of the child car seat must be so located and installed that
they are not liable, during everyday use of the vehicle, to become trapped by a movable
seat or in a door of vehicle.
● Periodically inspect the harness, pay particular attention to attachment points, stitching
and adjusting devices.
● Do not continue to use the child car seat if parts have become damaged or have loosened
after an accident.
● In the event of an emergency it is important that the child can be released quickly. This
means that the buckle is not fully tamper proof and so your child must be taught never
to play with the buckle.
● Ensure that all parts are locked in place correctly and not penned in the adjustable seats
or doors.
● Do not use this child seat at home. It's not designed for home use and should only be
used in your car.
● We recommend using the baby car seat on the back seat of cars.
● Before each journey check whether the child car seat is installed firmly.
● The back rest of the child car seat system have to rest flat against the back of the vehicle
seat. If necessary, adjust the head rest of the vehicle seat.
● The buckle of the safety car seat belt can't too close to the below of armrest. Please
contact the child restraint manufacturer if in doubt about this point (Fig.3-2).
● When you drive without a child in the child restraint system, always secure the system
with the adult belt.

4.1 Preparation for installation

Pull to unlock (Fig. 1) and simultaneously pull out the fixing connector (Fig. 2). Rotate the
connectors in the correct direction (Fig. 3).
4.2 Installation in the car − ISOFIT fixing system (partially universal)
In order to lock the stabilizing attachment install two latch arms on the connectors located in
the seat. Make sure that you hear a clear "click" sound (2x), and that green marks are visible
(Fig. 5).
Place the shoulder belt in the shoulder belt guide, and the lap belt under the armrest (Fig. 6).
Warning! The lap belt section must be as low as possible over the child's hips.
Place your child in the seat. Lock the belt in the buckle until you hear a "click" (Fig. 7).
Make sure the belt is not twisted. The lap belt should be placed just above the hips (Fig. 8).
FR
15

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kkexpan

Table des Matières