Adjusting The Height Of The Headrest; Removing The Seat; Removing The Cover - Kinderkraft Expander ECE II + III Guide D'utilisation

FR
4.3 Installation in the car − Fitting the vehicle seat belt (universal)
Pull the seat belt and guide it in front of the child up to the vehicle seat belt buckle. Push the
buckle tongue into the buckle in the seat until you hear a "click" (Fig. 9).
Separate the lap belt and the shoulder belt section at the buckle. The lap belt should be placed
below the armrest in a red guide located under the armrest. The shoulder belt should be
placed over the armrest (Fig. 10).
Place the lap belt section in the red belt guide also on the other side of the seat base (under
the armrest). Warning! The lap belt section must be as low as possible over the child's hips.
Place the shoulder belt section in the shoulder belt guide (Fig. 11).
Make sure the belt is not twisted. The lap belt should be placed just above the hips (Fig. 8).

4.4 Adjusting the height of the headrest

Grasp the adjustment handle behind the headrest and pull it slightly up (Fig. 12).
You can now adjust the headrest to the desired height. As soon as you release the adjustment
handle, the headrest is fixed in place (Fig. 13).
4.5 Using the storage compartment
To use the storage compartment, you must eject it from the base. Pull the storage
compartment out of the base
to close it (Fig. 14).
Warning! Do not put hot liquids in the open storage compartment. Do not place or put objects
of excessive weight in the storage compartment.

4.6 Removing the seat

Pull the belt out of the belt guides (Fig. 15). Press the release buttons on the fixing connector
until you hear a clear "click" (Fig. 16). Remove the car seat (Fig. 17).

5.1 Removing the cover

Remove the cover from the back and the base. Start in the areas marked with arrows (Fig. 18).
Press the headrest adjustment button and pull the headrest up. Remove the cover from the
sides of the seat (Fig. 19).
Pull the upper part of the cover. Start from the areas marked with arrows (Fig. 20).
5.2 Cleaning the car seat
The cover can be washed in a mild detergent for delicate fabrics at 30°C. Do not spin or tumble
dry in a tumble dryer (the fabric may separate from the padding). The car seat cover should be
cleaned according to the washing instruction (placed inside the cover).
Plastic parts can be cleaned with soap and water. Do not use strong cleaning agents.
16