SKF TMHP 15 Mode D'emploi page 5

Safety recommendations
As high pressures/forces constitute a potential safety
risk, the following instructions must be considered:
• The equipment should only be operated by
trained personnel.
• Do wear proper personal protective gear,
such as eye protection, protective gloves and
safety shoes, when operating the equipment.
• Always follow the operating instructions.
• Check the puller and all accessories carefully
before use.
Never use even slightly damaged components.
• Make sure the force rating of the puller exceeds
calculated maximum withdrawal force.
• Ensure that the puller legs are properly secured
around the workpiece.
Each claw must be fully engaged.
• Make sure the force is equally distributed in all
three arms.
• Make sure all air has been removed from the
hydraulic system, before putting the equipment
under pressure.
• Always use a pressure gauge.
• Always prevent the workpiece/tool from being
projected upon sudden release of pressure
(e.g. by use of retaining nut).
• Never use the equipment above the stated
maximum pressure.
• Use protective goggles.
• Cover the work with a protective blanket or
shield while force being applied.
• Never modify the unit.
• Use original parts only.
• Only use clean, recommended hydraulic oils
(e.g. SKF LHMF 300, LHDF 900 or similar).
• In case of any uncertainties as regards the use
of the puller, contact SKF.
EU Declaration of Conformity
TMHP 15/30/50
We, SKF MPT, Meidoornkade 14, 3992 AE Houten,
The Netherlands herewith declare under our sole
responsibility that the products described in these
instructions for use, are in accordance with the
conditions of the following Directive(s):
MACHINERY DIRECTIVE 2006/42/EC
and are in conformity with the following standards:
EN-ISO 12100-1,
EN-ISO 12100-2,
EN-ISO 14121-1,
EN-ISO 4413
Houten, The Netherlands, October 2022
Guillaume Dubois
Manager Quality and Compliance
UK Declaration of Conformity
TMHP 15/30/50
We, SKF MPT, Meidoornkade 14, 3992 AE Houten,
The Netherlands herewith declare under our sole
responsibility that the products described in these
instructions for use, are in accordance with the
conditions of the following Directive(s):
Supply of Machinery (Safety) Regulations 2008
(2008 No. 1597) and are in conformity with the
following standards:
EN-ISO 12100-1,
EN-ISO 12100-2,
EN-ISO 14121-1,
EN-ISO 4413
The person authorised to compile the technical
documentation on behalf of the manufacturer is
SKF (U.K.) Limited, 2 Canada Close, Banbury,
Oxfordshire, OX16 2RT, GBR.
Houten, The Netherlands, October 2022
Guillaume Dubois
Manager Quality and Compliance
3
EN