Dometic SANIPOTTIE 962 Mode D'emploi page 3

OPErATION
Prepare toilet for use
1 . CAUTION! With seat lid closed, pull
flush handle to open slide valve, then
push to close. This relieves air pressure
that may be created in lower holding
tank due to changes in temperature or
altitude.
2 . Remove water cap and fill upper tank .
Replace cap .
1
4
Use toilet
1 . CAUTION! BEFORE EACH USE, with
seat lid closed, pull flush handle to open
slide valve, then push to close. This
relieves air pressure that may be created
in lower holding tank due to changes in
temperature or altitude.
1
Empty holding tank
CAUTION! MAKE SURE slide valve
handle is all the way in.
1 . Unlatch upper unit by disengaging side
latches and lift from holding tank .
2 . Carry holding tank to permanent toilet
facility .
1
MSD Models: Pull flush handle to open flush valve . Pump out holding tank through
boat's discharge fittings according to boat manufacturer's instructions .
3 . Pull flush handle to open slide valve .
4 . Pour deodorant directly into lower tank,
then close slide valve .
bowl with slide valve closed.
2
2 . Use toilet . (If flushing solids, press bellows
pump to add water to bowl before use .)
3 . Pull flush handle to release waste into lower
tank .
4 . Press bellows pump one or more times to
rinse bowl . Push flush handle to close valve .
2
3 . Remove cap and empty contents into
permanent toilet .
4 . Rinse tank thoroughly, replace cap and
reassemble unit and prepare for use .
2
CAUTION! Never pour deodorant into
3
3
3
3