Lotus CW-74ET Manuel D'instructions page 19

The appliance is supplied without the connection cable.
In the event that it has to be substituted, proceed as follows:
Disconnect the power supply.
- Remove the back panel
- Disconnect the cable from the junction-box situated at the back.
- Loosen the cable blocker and pull out the cable..
- Push the connection cable through the cable blocker, connect the conductor wires to the corresponding terminals in the
junction box and fix them into place.
- Block the cable with the cable blocker, and reassemble the back panel. The earth wire must be longer than the others
so that if the cable blocker should break, it will disconnect after the tension wires.
N.B. The connection cable must have the following characteristics: it must be at least type H05 RN-F (resistant to
a temperature of at least 150°), and must have an adequate section for the power of the appliance (see technical
data table).
The appliance must be connected to an equipotential system. The connection screw is positioned at the back of the
appliance and is identified by the
Attention! The manufacturer will neither be held responsible for, nor will give any compensation during the guarantee
period for any damage caused, and which is due to inadequate installations not compliant with the instructions.
Before using the appliance for the first cooking, it is necessary to clean it carefully, especially the grill (see paragraph
"cleaning and care").
Check the connection of the appliance and start it up following the instructions.
Attention: Use the appliance only under surveillance.
- The drip pan may only be opened when the appliance is cold.
The grill scan be used to cook meat, würstel, sausages, fish, vegetables, etc.
Check that the drip pan is inserted. Switch on the switch above the appliance. With model CW-78ET, it is possible to
use one half of the grill or to make the two halves work at different temperatures.
Turn the knob from "O" into the desired position between 50°C and 300°; The white and green lights come on.
The green light indicates the presence of electrical tension. The white light shows that the heating element is working;
when the temperature is reached, it goes out.
To turn off the appliance, turn the knob into position "O".
Attention! During cleaning, do not wash the external parts of the appliance with direct sprays of water or with
high pressure.
After every use, clean the appliance thoroughly. Daily cleaning after switching off the appliance ensures the perfect
functioning and long life of the appliance.
Before starting to clean the appliance, disconnect the power supply. The parts in steel must be washed with hot water
and neutral detergent, then rinsed thoroughly in order to eliminate all traces of detergent; after which, dried with a dry
cloth. Do not use abrasive or corrosive detergents. All residues of food must be removed from the grill with the proper
spatula.
GB
ELECTRIC CONNECTION
EQUIPOTENTIAL
symbol.
STARTING UP
INSTRUCTIONS FOR USE
TURNING ON
CLEANING AND MAINTENANCE
19
IE