Publicité
Power
Regular
Scrub
Plus
Cancel Drain
Figure 28/Ilus. 28
Figure 29/Ilus. 29
36
Special Features | Caractéristiques Spéciales | Caractísticas Especiales
Delicate
Wash
/Econo
(Special Features, continued)
Changing the Cycle Completion Signal
Volume
Models With No LED Display:
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press and hold down the right-most of the
two buttons labelled "Cancel Drain", as
shown in Figure 28, then press and hold the
On/Off button. When the light on the "Cancel
Drain" button you are pressing illuminates,
and the tone begins to sound, release both
buttons.
3. Press the "Cancel Drain" button you
previously pressed until the tone is at the
desired volume, or until it is silent.
4. Press the On/Off Button.
5. Close the dishwasher door. The Cycle
Completion Signal is now set, and you may
wash your dishes as usual.
Models With An LED Display:
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press and hold down the Delay Start
Button, then press and hold the On/Off
button. When the tone begins to sound and
the display shows a 0, 1, or 2 , release the
buttons.
3. Press the Delay Start Button button until
the tone is at the desired volume, or until it is
silent. The display will show a 0, 1, or 2 for
the volume level.
4. Press the On/Off Button.
5. Close the dishwasher door. The Cycle
Completion Signal is now set, and you may
wash your dishes as usual.
Additional Drying Heat
With this special feature you can raise the
temperature of the rinse water, which will
result in better condensation drying.
Front Control
1. Press and hold the left-most of the two
buttons labelled "Cancel Drain", as shown in
Figure 29, then press and hold the On/Off
button. When the LED display shows a "0" or
a "1", release both buttons. The light above
the left-most "Cancel Drain" button will begin
to flash.
2. Press the left-most "Cancel Drain" button
until the LED display shows a "1", indicating
that the Additional Drying Heat is enabled.
3. If you wish to disable the Additional Drying
Heat, press the left-most "Cancel Drain"
button again. The LED display will show a "0",
indicating that the Additional Drying Heat is
disabled.
4. Press the On/Off button. The light above
the left-most "Cancel Drain" button will stop
flashing. You may now wash dishes as
usual.
E n g l i s h
Publicité
