Screwdriver Safety Warnings - Dexter 20VIDV2-180.1 Mode D'emploi

FR FR
3. SCREWDRIVER SAFETY WARNING
ES ES
Hold power tool by insulated gripping surfaces, when performing an operation where
PT PT
the fastener may contact hidden wiring.
Fasteners contacting a «live» wire may make exposed metal parts of the power tool «live» and
IT IT
could give the operator an electric shock.
. If possible, always use clamps or a vice to hold your work.
EL EL
. Always switch off before you put the tool down.
. Ensure that the lighting is adequate.
PL PL
. Do not put pressure on the tool, such that it slows the motor down. Allow the bit to screw without
pressure. You will get better results and you will be taking better care of your tool.
RU RU
. Keep the area free of tripping hazards.
. Only use accessory bits in good condition.
UA KZ
. Before starting, check that there is sufficient clearance for the bit under the workpiece.
. Do not touch the bit away after operation. It will be very hot.
. Keep your hands away from under the workpiece.
UA KZ
. Never use your hands to remove dust, chips or waste close by the bit.
. Rags,cloths,cord,string and the like should never be left around the work area.
RO RO
. Support the workpiece properly.
. If you are interrupted when operating the tool, complete the process and switch off before
BR BR
looking up.
. Periodically check that all nuts, bolts and other fixings are properly tightened.
EN
. When using the tool, use safety equipment including safety glasses or shield. Hearing protection,
EN
and protective clothing including safety gloves. Wear a dust mask if the operation creates dust.
200