Subaru SOA801P001 Instructions D'installation page 3

2c
CONTINUE WITH FIRM TAPPING MOVING UPWARD BETWEEN
STRIKE POINTS #1 & 4 AT ½ INCH INTERVALS.
2d
THE DOOR EDGE GUARDS ARE MEANT FOR PERMANENT INSTALLATION AND ARE NOT TO BE REMOVED.
IF A DOOR EDGE GUARD IS REMOVED FOR ANY REASON, IT CANNOT BE REINSTALLED.
STARTING FROM EITHER THE TOP OR BOTTOM OF DOOR EDGE GUARD, LIGHTLY TAP NYLON REMOVAL TOOL ALONG GUARD EDGE
IN ½" INTERVALS MOVING DOWN OR UP UNTIL ~2" OF DOOR EDGE GUARD IS DISENGAGED. REPEAT THIS PROCESS AT OTHER END.
ONCE ~2" OF BOTH TOP AND BOTTOM OF DOOR EDGE GUARD IS DISENGAGED, CONTINUE UP OR DOWN ENTIRE DOOR EDGE GUARD
PART NUMBER:
SOA801P001xx
ONCE FULLY ENGAGED, PROGRESSIVELY TAP UP ENTIRE LENGTH OF DOOR EDGE
GUARD. IF FULLY SEATED, A SOLID "THUD" SHOULD BE HEARD.
IF NOT HEARD, REPEAT STEP 2c.
Door Edge Guard Removal
A NEW DOOR EDGE GUARD KIT MUST BE USED.
~½"
LENGTH UNTIL REMOVAL IS COMPLETE.
DATE:
ISSUE:
04-17-17
REV. -
~½"
VISUALLY ENSURE DOOR EDGE GUARD IS FULLY
ENGAGED, THEN START BACK AT STRIKING POINT #1
TAPPING DOWNWARD ENTIRE LENGTH OF DOOR EDGE
~1"
=
THUD
THUD
~½"
SUBARU OF AMERICA
GUARD.
REPEAT ALL
DOORS
2c
~½"
PAGE
3/5