Zanussi AGS6435X Notice D'utilisation page 11

Burner overview
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
Ignition of the burner
Always light the burner before
you put on the cookware.
WARNING! Be very careful
when you use open fire in the
kitchen environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Push the control knob down and turn it
counterclockwise to the maximum gas
supply position ( ).
2. Keep the control knob pushed for
equal or less than 10 seconds. This
lets the thermocouple warm up. If not,
the gas supply is interrupted.
3. Adjust the flame after it is regular.
If after some tries the burner
does not light, check if the
crown and its cap are in correct
positions.
WARNING! Do not keep the
control knob pushed for more
than 15 seconds. If the burner
does not light after 15 seconds,
release the control knob, turn it
into off position and try to light
the burner again after minimum
1 minute.
CAUTION! In the absence of
electricity you can ignite the
burner without electrical device;
in this case approach the
burner with a flame, turn the
control knob counter-clockwise
to maximum gas supply
position and push it down.
Keep the control knob pushed
for equal or less than 10
seconds to let the
thermocouple warm up.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1
minute.
The spark generator can start
automatically when you switch
on the mains, after installation
or a power cut. It is normal.
The hob is supplied with the
progressive valves. They make
the flame regulation more
precise.
11