Bosch HSG736257M Mode D'emploi page 14

Operating the appliance
en
Cleaning the accessories
Before using the accessories, clean them thoroughly
using a cloth and warm soapy water.
Fitting the threaded bushes for the rotary
spit
From above, place the threaded bushes into the
1.
holes at the four corners of the universal pan.
Counter the ring nuts from below.
2.
Use a screwdriver to tighten the threaded bushes.
3.
14
1Operating the appliance
You have already learnt about the controls and how
p l i a n c e O p e r a t i n g t h e a p
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Hob
Switching on the gas burner
Notes
Appliances with a hob cover must only be switched
■
on if the hob cover is open.
The burner caps must always be positioned exactly
■
on top of the burner cups. The slots on the burner
cup must be free from obstruction. All parts must be
dry.
Ensure that the burner is not subjected to draughts
■
caused by air conditioning systems, fans or similar
appliances.
Press the control knob for the required burner and
1.
turn it to the — position.
The gas burner ignites.
Keep the control knob pressed for a few seconds
2.
until the flame stabilises.
Set the desired flame setting.
3.
Setting Meaning
Economy flame, lowest power
˜
Large flame, highest power
—
The flame is not stable between positions Û and —.
Always select a position between — and ˜.
If the flame goes out
Switch off the control knob. Wait one minute and switch
the burner on again.
:
Warning – Risk of fire!
If the flame goes out, gas will escape. Never leave the
gas burner unattended during operation. Ensure that
there are no draughts.
If the gas burner does not ignite
In the event of a power cut or damp ignition plugs, light
the gas burner with a gas lighter or a match.
Switching off the gas burner
Turn the control knob for the required hotplate to
position Û.