Installation Instructions; Before Using Your Appliance; Installation Of Your Appliance; Electrical Connection - Accucold ACR45L Manuel D'instruction

INSTALLATION INSTRUCTIONS

Before Using your Appliance

•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door, if it is not already attached. (See page 8.)

Installation of your Appliance

•
The appliance is designed for built-in or recessed or free standing installation for indoor use only.
•
Place your appliance on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
•
For free standing installation, 5" (127mm) of space between the back and sides of the unit, and 4"
(102mm) at the top, are suggested, which allows the proper air circulation to cool the compressor and
condenser. Even for built-in installation, it is a must to keep ¼" (6.35mm) space on each side and at
the top and 2" (51mm) at the rear. Take care that the air vent at the front of the appliance is never
covered or blocked in any way.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don't install in a location where the temperature will fall below 60°F (16°C). For
best performance, do not install the appliance behind a cabinet door or block the base grille.
•
Avoid locating the unit in moist areas.
•
Plug the appliance into an exclusive, properly grounded wall outlet.

Electrical Connection

Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
This appliance requires a standard 115/120 Volt AC ~60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
WARNING
7