Troubleshooting - Accucold ACR45L Manuel D'instruction

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
• Appliance is not connected to a power
supply.
Appliance
• The appliance is turned off.
does not
• Tripped circuit breaker or a blown fuse.
operate.
• The temperature is not set correctly.
• The ambient temperature could require
a lower temperature setting.
• The door was opened too often.
Appliance is
• The door was not closed completely.
not cold
• Door is not hermetically sealed.
enough.
• The condenser is too dirty.
• The ventilation opening is blocked or too
dusty.
• The room temperature is higher than
average.
• A large amount of food has been added
to the unit.
Appliance
turns itself on
• The door is opened too often.
and off
frequently.
• The door is not closed completely.
• The door gasket does not seal properly.
• Appliance is not connected to a power
supply.
The light does
• Tripped circuit breaker or a blown fuse.
not work.
• The light was switched off on the
control panel.
• The appliance is not properly leveled.
Vibrations
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
The appliance
appliance.
seems to
If temperature fluctuations occur, the contraction and expansion of the inner walls
make too
may cause popping and crackling noises.
much noise.
• The appliance is not properly level.
• The appliance is not properly level.
The door will
• The door was reversed and not
not close
properly installed.
properly.
• The gasket is dirty.
• The shelves are out of position.

TROUBLESHOOTING

POSSIBLE CAUSE
• Connect the appliance.
• Switch on the appliance.
• Switch on circuit breaker or replace
fuse.
• Check the set temperature.
• Set a lower temperature.
• Do not open the door more often than
necessary.
• Close door properly.
• Check the door seal and clean or
replace.
• Clean the condenser when
necessary.
• Clear the obstructions and clean the
dust.
• Put the appliance in a cooler place.
• Leave the appliance to work for a
while until the set temperature has
been reached.
• Do not open the door more often than
necessary.
• Close door properly.
• Check the door seal and clean or
replace.
• Connect the appliance.
• Switch on circuit breaker or replace
fuse.
• Switch on the light.
• Level the appliance with the
adjustable feet.
• Level the appliance with the
adjustable feet.
• Level the appliance with the
adjustable feet.
• Check the door hinge and
reassemble correctly.
• Clean the door gasket.
• Check the shelves and refit correctly.
16
REMEDY