Installation Instructions; Key Eject Lock - Accucold MED2 Serie Mode D'emploi

Use two or more people to move and install your appliance. Use two or more people to move and install your appliance.
Failure to do so can result in back or other injury. Failure to do so can result in back or other injury.
ALLOW APPLIANCE TO SIT UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO
ALLOW THE COMPRESSOR LUBRICANT TO DRAIN.
1.
Remove packaging materials.
2.
Remove tape and glue residue from surfaces before turning on the appliance. Rub a Remove tape and glue residue from surfaces before turning on the appliance. Rub a
small amount of liquid dish soap over the adhesive with your fingers. Rinse with warm
water and dry.
3.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your appliance. remove tape or glue. These products can damage the surface of your appliance.
4.
When Moving Your Appliance:
Your appliance is heavy. When moving the appliance for cleaning or service, be sure to
protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or
"walk" the appliance when trying to move it, because floor damage can occur. "walk" the appliance when trying to move it, because floor damage can occur.
5.
Clean Before Using:
After you remove all of the packaging materials, clean the inside of your appliance ter you remove all of the packaging materials, clean the inside of your appliance
before using it. See cleaning instructions in Appliance Care.
6.
Some upright models have leveling legs. Level as necessary for best
operation.
7.
If your appliance has casters, after moving into place, lock the brakes on those casters If your appliance has casters, after moving into place, lock the brakes on those casters
supplied with brakes. Always unlock before moving the appliance for cleaning. supplied with brakes. Always unlock before moving the appliance for cleaning.
Key Eject lock (some models):
To lock or unlock the appliance, you must hold the key in the lock while turning. The lock is
spring loaded, so the key cannot be left in the lock.
If the key is lost, contact your dealer or SUMMIT APPLIANCE for a replacement. Always If the key is lost, contact your dealer or SUMMIT APPLIANCE for a replacement. Always
give the model and serial number of your appliance when requesting a replacement give the model and serial number of your appliance when requesting a replacement key.
Keys for most models can be ordered online at
A NOTE ABOUT DOOR SWING:
Due to their wiring and controls, the doors on all MED2 units cannot be reversed in the
field. When ordering in the future, always specify whether you need a right hand or left When ordering in the future, always specify whether you need a right hand or left
hand (option "LHD") door swing. All units ship with a right hand door swing unless specified hand (option "LHD") door swing. All units ship with a right hand door swing unless specified
differently at the time of order.

Installation Instructions

Excessive Weight Hazard !
UPRIGHT FOR 24 HOURS BEFORE TURNING ON, TO
vy. When moving the appliance for cleaning or service, be sure to
the lock while turning. The lock is
www.summitappliance.com/support www.summitappliance.com/support
4
ingers. Rinse with warm
cannot be reversed in the