tormatic W-800 Manuel D'instructions page 53

Term of the Guarantee
Dear Customer,
During production, the garage door operator you have purchased has undergone various checks by the manufacturer
to ensure that it is of impeccable quality. Should this operator or parts of it prove to be of no use or limited use as
a result of proven material or manufacturing defects, we shall rectify this, at our discretion, through free-of-charge
repair or replacement. We shall not accept any liability for damage as a result of unsatisfactory fitting and installation,
improper putting into service, incorrect operation and maintenance, excessive use and overloading as well as any
alterations or modifications carried out to the operator and accessory parts by the customer. The same shall also
apply for damage incurred during transit or as a result of force majeure, external influences or natural wear as well
as special atmospherical stresses. We cannot accept any liability following alterations or modifications of functional
parts carried out by the customer. We must be notified of any defects immediately in writing; on request, the parts
in question are to be made available to us.
We shall not bear the costs for dismantling and installation, freight, and carriage. If a complaint is proven to be
unjustified, the customer must bear our costs.
This guarantee is only valid in conjunction with the signed invoice and commences on the day of delivery. The
manufacturer guarantees that the product is free of defects. The warranty is granted for a period of 24 months, in
as far as the test report has been properly filled out. Otherwise the warranty shall expire 27 months after the date
of manufacture.
Maintenance / Checks
For your safety, we recommend that the door system be checked before initial use and as needed -
but at least once a month - by a specialist. We recommend consulting a specialist company.
Monitoring the force limit
The operator control unit features a 2-processor safety system to monitor the force limit. In an end position or
after restarting, the integrated power disconnection is tested automatically. Prior to commissioning and once
a month, the door system must be checked. The examination of the force limiting device must be carried out
according!
Caution:
Closing force set too high can lead to personal injury.
The force for the OPEN drive can be adjusted in menu step 5 and the force for the CLOSE drive in step 6.
Cleaning / Care
Always pull the mains plug before working on the door or on the drive! If necessary, wipe the drive
with a dry cloth.
W-800
Term of the Guarantee
53