Alecto DVC-135IP Mode D'emploi page 41

The "Add Device" screen appears.
Enter the password of the camera. The default password is "admin".
Please change this password when the camera is registered correctly.
Attention: Don't modify the Wired and Wireless buttons.
When the image appears, the camera is registered successfully. Now press
Camera Settings and select Change Password to assign your own unique
password to the camera. This is essential for safe use of the camera.
Method 2:
Make sure that the smartphone or tablet is registered on the same network as
the network on which the camera is registered.
Press + in the welcome screen of the AlectoCAM app to add a camera.
Then press QR Code.
The scanner of the smartphone or tablet (provided this function is supported) will
be enabled. Now scan the QR code located on the camera.
The Add Camera screen appears. In this screen, enter the password of the
camera ("admin").
Now press OK.
In some cases the camera of the smartphone or tablet may not be able to read
the QR code. If this happens, press "Cannot use QR code" at the bottom of the
screen. In the UID field, enter the UID code located at the bottom of the QR code
sticker and then enter the "admin" password.
Attention: Don't modify the Wired and Wireless buttons.
When the image appears, the camera is registered successfully. Now press
Camera Settings and select Change Password to assign your own unique
password to the camera. This is essential for safe use of the camera.