Alecto DVC-135IP Mode D'emploi page 39

2.3 CAMERA CONNECTION.
Use the supplied UTP cable to connect the camera to your internet router.
Connect the camera to the supplied adaptor and insert the adaptor (only for
indoor use) into a 230V mains wall socket.
It will now take 30 to 60 seconds for the camera to start-up. The camera will
indicate this by telling you what the status is in English.
As soon as the camera is properly registered on the router, start the AlectoCAM
app on your smartphone or tablet. Make sure that the camera and the
smartphone or tablet are connected to the same network. Keep in mind that
when using a router with 2.4 GHz and 5 GHz Wi-Fi, the smartphone or tablet
should be registered on the 2.4 GHz, otherwise the camera may not be detected.
This camera only works on 2.4 GHz.
The blue LED indicates the network status:
LED remains lit: Power supply is connected for the first time.
LED flashes: Camera is making contact with the network.
LED off: Network is connected with the camera
Now start the AlectoCAM app on your smartphone or tablet.
Press + in the welcome screen of the AlectoCam app to add the camera.
Then press QR Code.
The scanner of the smartphone or tablet (provided this function is supported) will be
enabled. Now scan the QR code located on the camera.
QR code
or
Press LAN Search and press the UID code that appears.
- You'll find the UID code of the camera below the QR code.
ABCDEFGHIJKLMNOPQRST
UID code
The Add Device screen appears. On this screen, enter the password of the
("admin").
Now press the check mark ( ).