Auto Control Or Top Zone; Leds And Pushbutton Actions Fonctionnings - JRI SPY RF U Manuel D'utilisation

j)

Auto control or top zone

The type of action depends on the SPY RF configuration.
TOP ZONE = Transport mode
This function enables you to customise an action of measurement check-up. You just have to press shortly on
the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software Sirius.
k) Leds and pushbutton actions fonctionning
The green led is on 2'' when the measurement strarts and then flash each 1' in recording mode.
Specials fonctionning regarding the recorder using mode
Device set up in storage mode
Pushbutton pressing
Mode
OFF
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediatly
Mesure
Device set up in transportation mode
Pushbutton pressing
Mode
Off
Waiting setup
Starting measurements
Pushbutton
Delayed (date & time)
Immediatly
Mesure
©JRI
and AUTO CONTROL = Storage mode
T° OK: green LED is
+
on during 10".
Alarm LED (red) is on
+
during 10".
< 5"
-
Red led 2"
Green led 2" = begining of
measurements
-
-
Green led 10" = auto control
< 5"
-
Red led 2"
Green led 2" = begining of
measurements
-
Green led 10" = Top zone
5''> pressing <10''
The 2 leds are on and
flash at the same time.
-
-
-
-
-
5"<appui>10"
The 2 leds are on and flash at
the same time
.
-
-
The 2 leds are on and flash at
the same time
= Waiting for
starting measurements
The 2 LEDs are on and then
flash alternatively
= ending
measurements
The 2 LEDs are on and then
flash alternatively
= ending
measurements
20