Configuration; Measurement Start; Automatic Start - JRI SPY RF U Manuel D'utilisation

d)

Configuration

e)

Measurement start

The SPY RF has 2 starting mode:

automatic start

manual start
f) Automatic start
Your SPY RF starts recording:
automatically when the configuration is transferred,
It displays the temperature in °C degrees, channel number, measurement unit and memory status.
The green LED flashes every minute.
The temperature, threshold indicator, channel number and a red LED flashes every 15 sec in case the
threshold limit is overpassed.
at a programmed date and time:
when the logical input state changes (on channel number 2)
©JRI
SPY RF configuration is done from the Sirius software and then
transferred into your SPY RF by radio frequency.
dd / mm / yy
hh / mm / ss
Working LED (green):
2'' => starting measurements
+
then flashes every 1 minute
+
+
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
Working LED (green):
2'' => starting measurements
then flashes every 1 minute
18